Handling The Rear Shock Absorber And Gas Cylinder; Disposing Of The Rear Shock Absorber And Gas Cylinder - Yamaha YFM350S Service Manual

REAR SHOCK ABSORBER AND SWINGARM
a
EBS00485
HANDLING THE REAR SHOCK ABSORBER
AND GAS CYLINDER
WARNING
_
This rear shock absorber and gas cylinder
contain highly compressed nitrogen gas.
Before handling the rear shock absorber or
gas cylinder, read and make sure you
understand the following information. The
manufacturer cannot be held responsible
for property damage or personal injury that
may result from improper handling of the
rear shock absorber and gas cylinder.
• Do not tamper or attempt to open the rear
shock absorber or gas cylinder.
• Do not subject the rear shock absorber or
gas cylinder to an open flame or any
other source of high heat. High heat can
cause an explosion due to excessive gas
pressure.
• Do not deform or damage the rear shock
absorber or gas cylinder in any way. If the
rear shock absorber, gas cylinder or both
are damaged, damping performance will
suffer.
DISPOSING OF THE REAR SHOCK
ABSORBER AND GAS CYLINDER
Gas pressure must be released before dispos-
ing of the rear shock absorber and gas cylinder.
To release the gas pressure, drill a 2 ~ 3-mm
hole through the gas cylinder at a point a
50 mm (1.97 in) from its end as shown.
WARNING
_
Wear eye protection to prevent eye damage
from released gas or metal chips.
– 56 –
CHAS