Chassis; Checking The Front Brake Pads; Adjusting The Parking Brake - Yamaha YFM350S Service Manual

CHECKING THE FRONT BRAKE PADS/

ADJUSTING THE PARKING BRAKE

CHASSIS

CHECKING THE FRONT BRAKE PADS
1. Remove:
• front wheels
Refer to "FRONT WHEEL AND WHEEL
HUB" in chapter 6. (Manual No.: 3GD-AE5)
2. Check:
• brake pads
Wear indicator 1 almost in contact with the
brake disc → Replace the brake pads as a
set.
Refer to "FRONT BRAKE" in chapter 6.
(Manual No.: 3GD-AE5)
Brake pad wear limit a
1.0 mm (0.04 in)
3. Operate the brake lever.
4. Install:
• front wheels
Refer to "FRONT WHEEL AND WHEEL
HUB" in chapter 6. (Manual No.: 3GD-AE5)
ADJUSTING THE PARKING BRAKE
1. Check:
• parking brake cable end length a
Out of specification → Adjust.
Parking brake cable end length
64 ~ 68 mm (2.52 ~ 2.68 in)
2. Adjust:
• parking brake cable end length
M MMM M MMM M M MMM
a. Loosen the locknut 1 and adjusting bolt 2.
b. Slide back the rubber cover.
c. Loosen the locknut 3.
d. Turn the adjusting nut 4 in direction b or
c until the specified brake cable end length
is obtained.
e. Tighten the locknut 3.
f. Slowly turn the adjusting bolt clockwise until
resistance is felt.
g. Turn it 1/8 counterclockwise.
h. Tighten the locknut 1.
Locknut
16 Nm (1.6 m · kg, 11 ft · lb)
– 32 –
CHK
ADJ
M M MMM M M MMM M M MMM M MMM