Table of Contents
Advertisement
The configuration and operation of the IC.10X is
quite straight-forward and if you have understood our
previous section on the IC.20, you will have no problem
extending that knowledge to the IC.10X.
IP Address
The IC.10X has an ID button on the rear panel. This
switch is used in conjunction with Axia iProbe software
or the BootP utility as described in detail at the begin-
ning of this chapter.
The IP address may also be changed from the Sys-
tem page of the configuration as shown in Figure 3-14.
Remember that if you change the IP address, you will
lose the connection to your web browser and it will be
necessary to "point" your browser at the new IP address
to restore the connection.
Web Page Configuration
The web pages of the IC.10X will look familiar since
it is simply an extension of the IC.20 channel capacity.
Home Page
The IC.10X has only two options on the home page
as shown in Figure 3-12.
•
Intercom Expansion Configuration
•
System Parameters
Figure 3-12: IC.10X Home Page
Intercom Expansion Configuration
This page simply allows you to specify the Label of
the IC.20 master to which you are associating the expan-
sion and which bank of 10 stations you are assigning to
this module. You may have more than one IC.10X as-
sociated with an IC.20 master - just be sure to specify
different channel ranges for each expansion chassis.
System Page
The configuration contains the familiar IP settings,
Figure 3-13: IC.10X Expansion Configuration
password and Firmware Version sections that are fully
described earlier in this chapter. The IP address, other
network settings, syslog server, password, firmware up-
dates are all handled in a manner identical to that de-
scribed previously for the System Page of the IC.20 main
station.
It is highly recommended that any IC.10X expander
chassis should run the same version of software as its
associated main chassis.
Figure 3-14: IC.10X - System Configuration Page
IC.20 with IC.10X
When you are using an IC.20 chassis with an IC.10X
expander, you will notice a change to the Key Assign
Version 1.2 July 2010
Advertisement
Table of Contents
