Installation Instructions; Before You Start - AutoCommand 20036 Installation Manual

AutoCommand Wire Harness
Color Function
Thick Pink Power(+12V)
Thick White Accessory
Thick Yellow Starter
Thick Blue Ignition 1
Thick Green Ignition 2
Black Ground
Color Function
White/Red Lock Common
Yellow/Green Unlock Normally Closed Relay output
White/Green Lock Normally Closed
Yellow/Red Unlock Common
Color
Yellow
Blue
Brown
Brown/White Alarm Disable
White/Black
Optional Shock Sensor Jack
Plug In Switch
Color
Red/Black Diesel "wait to start"
Red/White Remote Input
Green
Violet
Orange
Color Function
Gray Alarm Trigger
White Ground out while armed Output (-)
Green/White Trunk / Carburetor
Gray/Black Door Pin Switch
For vehicle specific wiring information -- consult the Blue Sheet
for general information and consult our Web sit for more specific
information. www.designtech-intl.com.
Page 4
Type Required
Yes
Relay output Yes
Relay output Yes
Relay output Yes
Relay output Maybe - Consult Wiring Guide
Yes
Type Required
Relay output No
No
Relay output No
Relay output No
Function Type
Lights Relay output No
Horn Relay output No
Acc. Pulse/Dome Light Output (-)
Output (-)
Ignition 3 Output (-)
Plug In LED
Function Type
Input (+/-)
Input (-)
Tach Input
Hood Input (-)
Brake Input (+)
Type Required
Input (-) No
No
Output (-) No
Input (-) No
20036 - 20038
If you are working on a newer car, you may notice bright yellow tubes or
harnesses underneath the steering column area. These are the "SRS" or AIR
BAG wires. DO NOT tamper with these wires in any way, since this could
result in personal injury and/or damage to the air bag system.
Battery gases are explosive. Do not smoke while working near the car's
battery.
When fishing wires through the car's firewall, be sure to protect them from
sharp metal edges and from hot surfaces on the engine.
NOTE: Some installers hook a battery charger up to the vehicle's battery
Required
during the installation. This is fine, but it must be removed before running
the vehicle under remote car starter control.
No
Maybe

INSTALLATION INSTRUCTIONS

No

1 BEFORE YOU START

Take this time to read through the entire installation manual. Reading
the manual now will save significant time in the long run. ALL STEPS
ARE CRITICAL.
The installation information section or our web site www.designtech-
intl.com is available 24 hours/day to provide you with up to date vehicle
wiring information for your particular vehicle if needed.
Required
No
No
Wire Harnesses: Always check your wire harness before installing to
No
make sure that it matches the list/drawing on page 4 of the manual. You
Yes
Yes
can use the BLUE WIRE COLOR SHEET to help determine the col-
ors of the wires in your vehicle -- but be sure to always check these using
a volt-meter since vehicle wire colors can change from year to year in
vehicles.
When you have read the entire manual, and paid close attention to every
step, start the installation by putting the Yellow WARNING STICKER
under the hood. Pick a surface that is readily visible with the hood open
and will not be easily covered with grime. Make sure that the surface is
clean and grime free before applying the sticker.
20036 - 20038
!! WARNING !!
!! CAUTION !!
Page 5