Introduction; Important Safety Instructions; Installation - Toshiba 15CL7A Owner's Manual

Introduction

Important Safety Instructions

Be sure to observe the following instructions and precautions to ensure safe use of this TV.
The exact power cord will vary according to the country or region.

Installation

Always connect the power plug to an electrical outlet equipped with
the following:
For 15CL7A, 15CL7E, 15CL7T: Use 100 – 240V AC 50/60 Hz
For 20CL7A, 20CL7E, 20CL7T: Use 100 – 240V AC 50/60 Hz
Never use the TV outside the specified voltage range. It may cause a fire
or an electric shock.
WARNING ABOUT THREE-WIRE GROUNDING-TYPE PLUG:
Never remove the grounding pin on the power plug. This system is
equipped with a three-pin grounding-type power plug. This plug will
only fit a grounding-type power outlet. This is a safety feature. If you
are unable to insert the plug into the outlet, contact an electrician to
replace the wall outlet.
Never defeat the purpose of the grounding plug.
Never insert or remove the power plug with wet hands.
This may cause electric shock.
Never place the TV in an unstable location, such as on a shaky table or
incline or in a location subject to vibration.
The TV may drop or fall down, which may cause injury or damage.
Never block or cover the slots and openings in the cabinet.
• Never place the TV so that it is facing upward or on its side.
• Never place the TV in a closet, bookcase, or other similar area where
the ventilation is poor.
• Never drape a newspaper, tablecloth, or curtain on the TV.
• When installing the TV near a wall, always keep the TV at least 10 cm
away from the wall.
• Never place the TV on a soft, unstable surface, such as carpet or a
cushion.
The inside of this TV will overheat if the ventilation holes are covered,
blocked, or sealed, which may result in a fire.
Never place the TV near a heater or in direct sunlight.
The surface of the cabinet or power cord may melt and result in fire or
electric shock.
100 –
100 –
Check!
100-2 100-240V AC
About the fuse
In a three-pin grounding-type plug, the
fuse fitted in this plug is approved by ASTA
or BSI to BS1362. It should only be replaced
by a correctly rated and approved type and
the fuse cover must be refitted.
3