Long 360 Series Service Manual page 146

DESCRIPTION
Axle Shafts
Backlash between differential pinion, planet gear and axle shaft
splines
Outside diameter of wheel shaft bushings (9, Fig. B.X/6)
Bore of seat for bushings in wheel hub
Interference fit of bushings in their seats
Bore of wheel shaft bushings (after fitting without reaming)
Diameter of axle shafts in correspondence of bushings
Assembly clearance of axle shaft in its bushing
Steering Joint
Thickness of adjustment shims
(S2,
Fig. B.X/6)
Thickness of wheel hub bearings adjustment shims (S,, Fig. B.X/6)
Front Wheel Drive Pivot
Diameter of trunnion pin
Bore of trunn-ion bushings
Assembly clearance between trunnion pin and bushings
Interference fit of bushing
Thickness of trunnion thrust washer
Max. osciliation of axle in both directions
Reduction Gearbox
Thickness of brake liner
Thickness of brake disc
Backlash of brake liner on shaft
Backlash of sliding sleeve and gear
Backlash of sliding sleeve and shaft
Power Train • 142
FITS AND TOLERANCES
ln. (mm.)
0.004 to 0.0042 0.010-0.106
1.8504 to 1.8512 47.000 to 47.020
1.8464 to 1.8485 46.900 to 46.950
0.0019 to 0.0047 0.050 to 0.120
1.5759 to 1.5775 40.030 to 40.070
1.5737 to 1.5748 39.975 to 40.000
0.0012 to 0.0037 0.030 to 0.095
0.004·0.006-0.008 0.10-0., 5-0.20
0.010·0.012 0.25-0.30
0.086-0.090-0.094 2.2-2.3-2.4-2.5
0.098-0.102-0.106 2.6-2.7-2.8-2.9
0.110-0.114-0.118 3·3.1-3.2
0., 22-0.126
1.4951 to 1.4961 37.9756 to 38.000
1.4969 to 1.5000 38.020 to 38.100
0.0008 to 0.0049 0.020 to 0.125
0.0025 to 0.0047
0.050 to 0.120
0.2008 to 0.2067 5.100 to 5.250
11
0
0.1547 to 0.1602 3.9-30 to 4.070
0.0978 to 0.1043 2.485 to 2.650
0.0028 to 0.0063 0.070 to 0.160
0.0028 to 0.0065 0.070 to 0.166
0.0004 to 0.0042 0.010 to 0.106