Connecting To The Electricity Supply; Products With Cast Iron Lid - New World Freestanding Gas Users Manual & Installation Handbook

INSTALLATION INSTRUCTIONS - GAS
CONNECT TO THE ELECTRICITY SUP-
PLY
(mains ignition models only)
Warning: This appliance must be earthed.
The flexible mains lead is supplied con-
nected to a BS 1363 fused plug, the plug
is fitted with the correct fuse.
Replace only with a fuse of the same rat-
ing and type.
The wires in the mains lead are coloured
in accordance with the following code:
Green and yellow = Earth,
Blue = Neutral,
E (Earth)
Green/Yellow
N (Neutral)
Blue
Brown = Live.
As the colours of the wires in the mains
lead for the appliance may not corre-
spond with the coloured markings identi-
fying the terminals in your plug, proceed
as follows:
1. The wire which is coloured green
and yellow must be connected to the
terminal marked E (Earth) or coloured
Green.
2. The wire which is coloured
blue must be connected to the terminal
marked N (Neutral), or coloured Black.
3. The wire which is coloured brown must
be connected to the terminal marked L
(Live), or coloured Red.
The plug and socket must be accessible
after installation. Should the mains lead
of the appliance ever require replacing,
this must be carried out by a qualified
electrician who will replace it with a lead
of the same size and temperature rating.
Important: - ensure that you route all
mains and electrical cables and flexible
tubing well clear of any adjacent heat
source.
Under no circumstances should the mains
electric cable be allowed to come into
contact with the vertical oven flue tubes
on the rear of the appliance.
(Neutral),

PRODUCTS WITH CAST IRON LID

must be connected
(WHERE FITTED)
marked N (N eu 3.
be connected to the terminal marked
A 55mm clearance is required from the
Black.
L (Live)
(Live),
back of the hotplate to the rear wall, to
3. The wire which
allow the lid to be opened fully. To ensure
Brown
must be connected
this clearance is maintained, the infill
The plug and socket must be accessible
piece (supplied) should be fitted using the
marked L (Live),
after installation. Should the mains lead of
instructions below.
The plug and
the appliance ever require replacing, we
Fitting the infill piece between the rear of
acce ssible after insta
recommend that this is carried out by a
the hob and the wall
quali ed electrician who will replace it with
Should the main
a lead of the same size and temperature
Fix the infill piece to the wall - using
appliance ever requ
rating.
suitable screws and wall fixings (not
supplied) - and ensure it is level with the
hotplate as shown.
Note: The 55mm clearance dimension
should not be reduced.
550mm
55mm