Advertisement
1995 Windstar
11. Install the crankshaft pulley using Vibration Damper and Seal Replacer T82L-6316-A.
12. Install crankshaft pulley retaining washer and bolt. Tighten bolt to 140-180 Nm (103-132 lb-ft).
13. Install pulley to vibration damper, if removed. Tighten retaining bolts to 26-38 Nm (19-28 lb-ft).
14. Install brace to A/C bracket and P/S bracket. Tighten three M8 retaining bolts to 20-30Nm (16-22 lb-ft). Tighten one M10 retaining bolt to 10-54 Nm (31-41 lb-ft).
15. Connect radiator lower hose tube . Tighten bolt securely.
16. Connect crankshaft position sensor electrical connector.
17. Connect camshaft position sensor electrical connector.
18. Connect heater water outlet tube to water pump . Install retaining bolts and tighten to 8-11.5 Nm (71-102 lb-in).
19. Install water pump pulley and retaining bolts. Tighten bolts to 40.3-54.7 Nm (30-40 lb-ft).
20. Position drive belt over pulleys and drive belt tensioner . Refer to
21. Install engine into vehicle. Refer to procedure in this section.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSSW/~MUS~LEN/20/S...
Section
03-05.
3
6/3/2009
Advertisement
