Installation - Klutch 7500K Welder/Generator User Manual

ASSEMBLY
1. Install Axle To Frame
1.1 Carefully lift main welder frame approximately 12 inches off the ground. Be careful to secure
the unit to prevent it from falling.
1.2 Note the mounting holes on the axle flange and match it up with the mounting holes in the
main unit frame. The axle gets mounted on the end of the welder controls. Use the supplied bolts,
washers, lock washers and nuts to secure axle bracket to the welder frame.
2. Install Wheels
2.1 Slide wheel onto axle
2.2 Slide large supplied washer onto axle.
2.3 Hold wheel and washer on the axle buy installing large cotter pin into the hold at the end of the
axle.
2.4 Repeat for other wheel.
3. Install Handles
3.1 Identify which handle goes on each side.
3.2 Use supplied hardware to fasten the large flange with 4 mounting holes to the side of the
frame.
3.3 Use the supplied hardware to mount the tube leg to the bottom of the welder frame.
3.4 Repeat for each side.

INSTALLATION

1. ENGINE FUELING - Fill the fuel and oil needed for the engine. See Engine Operator's manual for
details.
2. WELD CABLE CONNECTION - Refer to your welding electrode manufacturer packaging for
suggestions of weld polarity.
Be aware that the Electrode Holder And Cable will be electrically HOT when the engine is started
and the weld cables are connected to the weld output connections.
2.1 DC Electrode Positive
2.1.1 Connect the quick connector on the end of the electrode holder and cable to the positive
(+)weld output connection on the front of the welder.
2.1.2 Connect the quick connector on the end of the ground clamp and cable to the negative (-)
weld output connection on the front of the welder.
2.2 DC Electrode Negative
2.2.1 Connect the quick connector on the end of the electrode holder and cable to the negative (-)
Page 9 of 18