Screen Display; Remote Control 2 Performance; Pairing - ReSound Unite 2 User Manual

Screen display

To conserve battery life, the remote Control 2 has a standby fea-
ture that automatically puts the remote Control 2 into a "sleep"
mode after 20 seconds of non-use. Whenever the display is dark,
simply press any button on the keypad to awaken the display and
then perform the desired action.

Remote Control 2 performance

The remote Control 2 performs best when buttons are pressed
one step at a time rather than in rapid sequence. When adjust-
ing volume, for example, briefly press a button and wait a short
moment for the beep tones* to be heard before continuing. This
tip applies to all button use but is especially relevant to volume
adjustments.
*Please note that tones may have been disabled by your hearing
care professional during fitting
18
i

Pairing

Note! The following information is intended primarily for your hear-
ing care professional, who in most cases will complete the tasks
that are necessary before the Remote Control 2 can be used with
your hearing instruments. However, the process is designed to
be simple and should be easily accomplished by almost anyone.
Pairing is the process of setting up an exclusive com-
munication between your hearing instruments and your
remote Control 2. Your hearing care professional can set up pair-
ing during the fitting of your hearing instruments. Alternatively, you
can follow the below steps to pair your hearing instruments to the
remote Control 2:
1. Make sure the remote Control 2 is fully charged and is turned
ON. Your hearing instruments must be off – open the battery
doors.
2. Press the pairing button on the
remote Control 2 (11 on page 9)
one time. This will activate the pair-
ing mode which will be active for 20
seconds.
searching for hear-
ing instruments
19