Trip Functions - Chrysler 300 2010 Owner's Manual

Hide thumbs Also See for 300 2010:

Table of Contents

Unless reset, this message will continue to display each

time you turn the ignition switch to the RUN position. To

turn off the message temporarily, press and release the

MENU button. To reset the oil change indicator system

(after performing the scheduled maintenance) perform

the following procedure:

1. Place the ignition switch in the RUN position (Do not

start the engine).

2. Fully depress the accelerator pedal slowly three times

within 10 seconds.

3. Place the ignition in the OFF position.

NOTE: If the indicator message illuminates when you

start the vehicle, the oil change indicator system did not

reset. If necessary, repeat this procedure.

UNDERSTANDING YOUR INSTRUMENT PANEL 229

Trip Functions

Press and release the MENU button until one of the

following Trip Functions displays in the EVIC:

• Average Fuel Economy / Fuel Saver Mode

• Distance To Empty

• Elapsed Time

• Display Units of Measure in

Press the SCROLL button to cycle through all the Trip

Computer functions.

The Trip Functions mode displays the following informa-

Table of Contents