Getting Started; Setting The Current Clock Time - Andrew James 4 Day Automatic Pet Feeder User Manual

Getting started

1. Carefully turn the pet feeder upside down. Remove both battery doors by
squeezing the two tabs and gently pull each door away.
2. Keep the ON switch set to OFF. Insert four C size alkaline batteries into the
battery tray. DO NOT use old or cheap carbon batteries.
3. Close the battery doors, rotate the feeder right-side up and switch ON The
feeder will cycle one time until "12:00" is on the LCD display.
Note: Your pet feeder makes the food available in this sequence: Tray 1, Tray 2,
Tray 3 then Tray 4. When only one feed is required only fill Tray 1. For two feeds
Tray 1 and 2. Continue the sequence on for further feeds.

Setting the current Clock time

1. Press and hold the SET key for (2 seconds) to enter Clock SET mode. The
hour number will now begin to blink.
2. Press the MODE key to increase the hour. Once you have set the hour,
press the SET key to confirm the hour. The minute number will now blink.
3. To change the minute number, press the MODE key to increase the
minute. Once you have set the minute, press the SET key to confirm the
minute. Both the hour and minute numbers will now blink.
4. If needed, Press the MODE key to change between 12 or 24 hour time.
5. Press the SET key to confirm your current time setting and the numbers
will stop blinking.
8