Symbols; Important! Read Before Using Chain Saw - Jonsered CS 2117 EL Operator's Manual

SYMBOLS USED IN OPERATOR'S MANUAL:
Always disconnect power before performing
cleaning or maintenance work.
Always use approved safety gloves.
Clean your chain saw regularly.
Use approved face mask or safety goggles.
CAUTION!
Chain saws are dangerous! Careless or im-
proper use can result in serious or fatal injury.
Read operating instructions and make certain you
understand them thoroughly before using the chain
saw.
The chain saw is double-insulated.
Always use:
• Approved helmet
• Approved hearing protection
• Approved safety goggles or face mask
This product conforms to
applicable CE directives.
This product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling
of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
For more detailed information about recycling of this product, please contact your local council offi ce, your household waste disposal
service or the shop where you purchased the product.
IMPORTANT! BEFORE USING CHAIN SAW
• Read operating instructions carefully.
• Always observe the «Safe Use» recommendations on page 4.
• Check chain and guide bar for correct assembly and adjustment.
• Start the saw.
• Do not start sawing until an adequate amount of oil has
reached the chain.
• Incorrect chain tensioning increases wear on chain, sprocket
and guide bar, and may result in damage to these parts.
• Improper use of power cable may lead to serious motor damage.
CAUTION!
The chain saw must not be modifi ed in any way under any circumstances without the permission of the manufacturer.
Use only original accessories. Unauthorized modifi cations and/or accessories may cause serious or fatal injury of the
operator or others.
SYMBOLS ON THE CHAIN SAW:
Visual inspection.
Do not use a coiled extension cord.
Minimum wire cross-section:
Maximum cable length:
Voltage:
CAUTION!
Chain saws are dangerous!
Careless or improper use can
result in severe or fatal injury.
Noise emission to the environment according to the
European Community's Directive. The machine's
emission is specifi ed in «TECHNICAL SPECIFICATIONS»
page 3 and on label.
Do not expose saw to rain or moisture.
Disconnect power in case of damage to power cable.
Maximum permissible guide bar length.
Minimum wire cross-section:
Maximum cable length:
Voltage:
2
mm ²
1,5
30 m
230 V
IMPORTANT!
Do not use a coiled
power cable!
1,5 mm ²
30 m
230 V