APPROVALS .........................................................................................3
SAFETY .................................................................................................4
Required Ability ...........................................................................4
General .......................................................................................4
Uncrating .....................................................................................4
Leveling .......................................................................................4
Location.......................................................................................4-5
Clearances ..................................................................................5
Flue Gas Venting.........................................................................6
Water Piping ................................................................................7
Fuel Systems ..............................................................................7-8
Fuel Pump ...................................................................................9
Wiring Diagrams..........................................................................9
General .......................................................................................9
Filling ...........................................................................................9
Start Up .......................................................................................9
The burner and controls are listed by Underwriters' Laboratories Inc.
Accordingly, the burner bears one of the UL labels indicating periodic
inspection of the production of this equipment.
All ASME tanks are built to the standards of Section IV of the American
Society of Mechanical Engineers code and are stamped with their symbol.
The National Board of Boiler and Pressure Vessel Inspectors papers are
furnished upon request. The NB number and HLW symbol (to the right)
are on the plate located just below cleanout on tank. (May be viewed by
removing cleanout cover on jacket).
The heater and burner rating plates or labels provide valuable information.
When ordering parts or inquiring about a unit, be sure to include all
information from the plates. See the picture on page 2 for approximate
location of the heater rating plate.
The heater model number is structured as follows:
OIL BURNER NAMEPLATE DECAL
The oil burner's nameplate decal (see page 2 for the approximate location
on the burner) contains a burner KBTU/H input which should exactly match
the model input appearing on the first line of the heater's rating plate. The
oil burner series 940 or 941 indicates the burner equipped w/single or two
TABLE OF CONTENTS
Draining .......................................................................................11
General .......................................................................................11
Relief Valves ...............................................................................11
Flushing.......................................................................................11
Sediment Removal ......................................................................11
Lime Scale Removal ...................................................................11-12
Circulating Pump .........................................................................13
Soot Removal..............................................................................13
Vent System ................................................................................13
Water Too Hot .............................................................................20
Burner Won't Start .......................................................................20
TROUBLESHOOTING ..........................................................................22
APPROVALS
IDENTIFICATION
stage pump respectively, should match letter "O" or "T" of the heater model.
If these codes do not match, the oil burner may not be the correct model
for the heater model purchased, Contact your State dealer for further
information and replacement , if required.
3
A TYPICAL OIL BURNER NAMEPLATE DECAL
FIGURE 2.