Storage And Maintenance - Samsung 630 User Manual

Issues
Others
The cable/set top box remote control
does not turn the TV on or off, or adjust
the volume.
A "Mode Not Supported" message
appears.
Caption on TV menu is greyed out.
There is a plastic smell from the TV.
TV Signal information is unavailable in
the Self Diagnosis Test menu.
TV is tilted to right or left side.
The Channel menu is grey out
(unavailable).
Your settings are lost after 30 minutes
or every time TV is turned off.
You have intermittent loss of audio or
video.
The PIP menu is not available.
You see small particles when you look
closely at the edge of the frame of
the TV.
POP (TV's internal banner ad) appears
on the screen.
✎
This TFT LCD panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However,
there may be a few bright or dark pixels on the screen. These pixels will have no impact on the performance of the
product.
F

Storage and Maintenance

✎
If you remove the attached sticker on the TV screen, clean the residues and then watch TV.
'R QRW VSUD\ ZDWHU RU D FOHDQLQJ DJHQW GLUHFWO\ RQWR WKH
SURGXFW $Q\ OLTXLG WKDW JRHV LQWR WKH SURGXFW PD\ FDXVH D
IDLOXUH ¿UH RU HOHFWULF VKRFN
Solutions and Explanations
• Program the Cable/Sat remote control to operate the TV. Refer to Cable/Sat user manual for
SAMSUNG TV code.
• Check the supported resolution of the TV and adjust the external device's output resolution
accordingly. Refer to resolution settings in this manual.
• Caption can not be selected in the TV menu when connected via HDMI or Component.
• Caption must be activated on the external device.
• This smell is normal and will dissipate over time.
• This function is only available with digital channels from an Antenna / RF/Coax connection.
(P. 22)
• Remove the stand base from TV and reassemble it.
• The Channel menu is only available when the TV source is selected.
• If TV is in the Store Demo mode, it will reset audio and picture settings every 30 minutes.
Please change from Store Demo mode to Home Use mode in the Plug & Play procedure.
Press the SOURCE button to select TV mode, go to
ENTER .
• Check the cable connections and reconnect them.
• Loss of audio or video can be caused by using overly rigid or thick cables. Make sure the cables
are flexible enough for long term use. mounting the TV to the wall, we recommend using cables
with 90 degree connectors.
• PIP functionality is only available when you are using a HDMI, PC or components source.
• This is part of the product's design and is not a defect.
• Select Home Use under Plug & Play mode.
For details, refer to Plug & Play (Initial Setup). (P. 7)
&OHDQ WKH SURGXFW ZLWK D VRIW FORWK GDSSHG LQ D VPDOO
DPRXQW RI ZDWHU
MENU Setup Plug & Play
English