Echo CS-400 Instruction Manual page 16

Fuel tank cap
Starter handle
Choke control knob
Choke control knob
Unlock chain brake
CS-400
Choke control knob
CS-400
Oil tank cap
Chain brake
Open choke
Ignition switch
Start / Run
Purge pump
Choke
Lock Chain
Starter handle
brake
Open choke
SAE No. 30 ....... in summer
SAE No. 10 ....... in winter or when cutting
• When refueling, also refill chain oil.
• Securely hold the chain saw as shown and pull
starter handle several times until first firing sound.
OPERATION
• Push choke control knob all the way in.
• After choke control knob is pulled and then
knob is returned to original position,
throttle remains a little open (latch
condition).
• If engine is started in this latch condition,
chain starts to turn. Do not start engine
before chain brake is activated.
• Pull starter handle to start the engine.
• After starting the engine, squeeze throttle
NOTE
trigger slightly to release throttle latch and
If engine does not start after 5 pulls, repeat instruc-
pull front hand guard towards the operator
tions.
immediately.
(Chain brake unlocked position)
• Never use throttle latch for cutting.
• When engine starts, immediately squeeze throttle trig-
• Use the chain brake only in starting or in
ger to release the latch, otherwise damage to clutch
emergencies.
may result.
WHEN THE ENGINE IS WARM
• Move chain brake lever fully forward to lock chain
brake before starting.
• Confirm there is fuel and chain oil in the tanks.
• Move ignition switch to "RUN" position.
• Securely hold the chain saw as shown and pull
starter handle.
• Choke may be used if necessary, but be sure to push
14
it back on first firing sound.
NOTE
If engine does not start after 5 pulls, use cold start
procedure.
16
resinous trees.
WARNING
CAUTION