Porsche Cayenne Owner's Manual page 355

Putting vehicle into operation
After the battery is connected or after a com-
pletely discharged batterie is charged, the PSM
warning light lights up on the instrument panel and
a message appears on the multi-purpose display
of the instrument panel to indicate a fault.
This fault can be remedied with a few simple
steps:
1. Start the engine.
To do this, turn the ignition key or the control
unit (on vehicles that have Porsche Entry &
Drive) to ignition lock position 2 twice.
2. Perform a few steering movements and drive
a short distance in a straight line until the PSM
warning light goes out and the message is
erased from the memory of the multi-purpose
display of the instrument panel.
3. If the warnings does not go out, then:
Drive carefully to the nearest authorized
Porsche dealer.
Have the fault remedied by an authorized
Porsche dealer.
4. After the warnings disappear:
Stop the vehicle in a suitable place.
5. Perform adaptation of the power windows:
Please observe the chapter "STORING FINAL
POSITION OF THE DOOR WINDOWS" on
Page 104.
6. On vehicles with tire pressure monitoring:
Please observe the chapter "SETTING THE
TIRE TYPE AND SIZE" on Page 153.
Removing and installing battery
Danger!
Risk of short circuit and explosion, resulting
in serious personal injury and death.
Risk of damage to the alternator and elec-
tronic control units.
f Have the battery removed and installed only by
a qualified professional.
f Do not disconnect battery while the engine is
running.
f Disconnect and connect the battery only with
the greatest care. Danger of short circuit and
explosion.
f Do not tilt the battery when removing it.
Risk of caustic burns from escaping acid.
The battery is located in the battery box under the
left front seat.
If the battery is completely discharged, the vehicle
must be provided with external power at the jump-
lead starting points so that you can move the seat.
f Please observe the chapter "EMERGENCY
STARTING WITH JUMPER CABLES" on
Page 361.
Maintenance note
The seat mounting bolts must be replaced each
time they are loosened.
The bolts are micro-encapuslated and keep dust
and water out.
If this is not observed, it might not be possible to
attain the prescribed tightening torque of 37 ftlb
(50 Nm).
Minor Repairs
355