Advertisement
DANGER
!
ELECTRIC SHOCK OR FIRE HAZARD
READ ALL WIRE SIZING, VOLTAGE REQUIREMENTS AND
SAFETY DATA TO AVOID PROPERTY DAMAGE AND
Operation
1. Position the fan heater so that it stands upright on a firm,
level surface (When used as a portable) and at a safe distance
from wet locations and flammable objects.
2. Connect the fan heater to the proper electrical power. See
grounding instructions (Figure 2)
3. Set the thermostat dial to the maximum temperature.
4. Once the room reaches the desired temperature, turn the
thermostat dial back until heating element turns off. The heater
will cycle automatically around this preset temperature. To
increase temperature, turn the thermostat knob clockwise. To
lower temperature, turn the thermostat counterclockwise.
5. LOW setting on thermostat does not prevent heater from
turning ON. Turn power switch to OFF or unplug from wall to
prevent heater from turning ON. Before unplugging heater, turn
power switch to OFF position.
IMPORTANT: This heater has a built-in Fan Delay designed
to exhaust heat from the unit until the elements are cool
(Cool Down Cycle). This improves energy efficiency. The fan
may cycle on/off for a few minutes after the thermostat is set
to the LOW position or power switch is set to OFF. This is normal
and required to cool down heater and also prevent the safety
limit from nuisance tripping.
HOW TO RESET THE HEATER (SURESTOP
This heater is equipped with an internal safety limiting
thermostat and overheat protection circuit.
If SAFTEY LIMIT light illuminates, an abnormal condition has
turned off the heating elements. TO RESET, WAIT 10
MINUTES to allow the heater to cool down, then insert a
small screw driver tip into the hole on the front of the heat-
er marked "LIMIT RESET" and push firmly until you hear a
click.
KING ELECTRIC MFG CO · 9131 10TH AVENUE SOUTH · SEATTLE, WA 98108 · PH:206 762 0400 · FAX: 206 763 7738 · www.king-electric.com
SAVE THESE INSTRUCTIONS
OPERATION
!
OPERATION
SAFTEY LIMIT)
™
Thermostat Instructions
- At first, set the thermostat to "+" and let the heater operate
with full power input. When the room temperature reaches the
required value, turn the thermostat to the left until it switches
off.
- The thermostat will then switch on and off automatically to
control the room temperature according to the preset value and
keep the room temperature constant.
- When using the heater for the first time, you may notice a
slight emission of smoke. This is quite normal and it stops after
a short time. The heating element is made of steel and was
coated with a layer of protective oil during production. The
smoke is caused by the leftover oil as it is heated.
Grounding Instructions
- This heater is for use on 240 (or 208) volts. The cord has a plug
as shown in figure 2 (below). No adapter is available for this
blade configuration, and none should be used. The type outlet is
a 240 (or 208) volt grounding outlet. When properly installed, it
provides a ground connection through the cord to the heater to
protect the operator from electric shock.
- Be sure that the electrical receptacle is of the configuration
and capacity appropriate for the heater.
Figure 2
SPECIFICATIONS
BTU
13,000B
Watts
3,750W
Heating Area (ft2) 450 ft2
Power (Volts)
240V~60Hz
Amps
16A
Heat Settings 1
On/Off
Heat Settings 2
Thermostat
PLUG TYPE
20 amp 240 V
NEMA #6-20P
1
Advertisement
