Toyota Echo 2001 User Manual page 12

SU12026
"PANIC" SWITCH
Pushing the "PANIC" switch blows the
horn intermittently and flashes
headlight and tail lights.
The "PANIC" switch is used to deter the
vehicle theft when you witness anyone at-
tempting to brake into or damage your
vehicle.
The alarm will last for one minute. To stop
this in the midway, push the "PANIC"
switch once again, unlock any door with
the key or transmitter, open the trunk with
the key or turn the ignition key or turn the
ignition key from the "LOCK" to "ON" posi-
tion.
12
2001MY ECHO (U) L/O0008
To cancel the "PANIC" mode, unlock any
door with the key or wireless remote con-
trol transmitter, open the trunk with the
key from the "LOCK" to "ON" position.
The "PANIC" mode does not work when
the key is inserted in the ignition switch.
WIRELESS REMOTE
TRANSMITTER
The wireless remote control transmitter is
an electronic component. Observe the fol-
lowing instruction in order not to cause
damage on the transmitter.
"
Do not leave the transmitter on the
places where the temperature becomes
high such as on the dashboard.
"
the
Do not disassemble it.
"
Avoid knocking it hard against other
objects or dropping it.
"
Avoid putting it in water.
You can use up to 2 wireless remote con-
trol transmitters for the same vehicle.
Contact your Toyota dealer for detailed
information.
If the wireless remote control transmitter
does not actuate the doors or alarm, or
operate from a normal distance.
2001 ECHO (OM52440U)
"
Check for closeness to a radio trans-
mitter such as a radio station or an
airport which can interfere with normal
operation of the transmitter.
"
The batteries may have been con-
sumed. Check
transmitter. To replace the batteries,
CONTROL
see "Replacing transmitter batteries".
Replacing transmitter batteries
For replacement, use a CR2016 lithium
battery or equivalent.
CAUTION
Special care should be taken that
small children do not swallow the re-
moved transmitter battery or compo-
nents.
NOTICE
When replacing the transmitter bat-
tery, be careful not to lose the com-
ponents.
Replace the transmitter battery by the fol-
lowing procedures:
the batteries in the