INTRODUCTION ....................3 The DBI-1 Doorbell Interface provides realistic doorbell chimes throughout a home installed with a Niles MultiZone System. External contact closure and voltage triggers (for both a front and rear FEATURES AND BENEFITS ................3 door) are combined with a programmable trigger tone/delay to integrate with all Niles MultiZone Control Systems.
After unpacking and before installation, the installer should carefully inspect the contents. If any damage is discovered due to shipping, the installer should contact Niles Audio for assistance (see back cover or Warranty Card for contact information). Also, keep all packing materials in case the product ever needs to be returned to the factory.
INSTALLATION COSIDERATIONS The DBI-1 can be either mounted on the back of a cabinet or on a wall using screws (not includ- ed). Also, it can be placed on a shelf using the included adhesive rubber feet (see Figure 1 on •...
Page 5
O O R B E L L N T E R F A C E O O R B E L L N T E R F A C E...
Turning switch 1 ON enables a trigger tone that activates the audio sensing of the Paging when first powered on. The A4.6Ci contains the version letter in its serial number locat- Input of a Niles MultiZone System. Switches 2, 3 and 4 ON enable delay times. The delay ed on the bottom panel.
Chime Selection - Two banks of DIP switches (Chime Selection 1 and Chime selection 2) pro- Recording a Custom Chime - A mono analog audio signal can be recorded by the DBI-1 to vide independent selection of all the available chimes. The lowest number DIP switch takes create a Custom Chime.