Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Chevrolet Malibu 2010 Owner's Manual

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high beam,
push the turn signal/multifunction lever away from you.
This instrument panel cluster light
high beam lamps are turned on while the ignition is in
ON/RUN.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.

Flash-to-Pass

This feature lets the high-beam headlamps be used to
signal a driver in front of you that you want to pass.
Pull the turn signal/multifunction lever toward you until
the high-beam headlamps come on, then release the
lever to turn them off.
3
comes on if the

Windshield Wipers

The windshield wiper lever is on the right side of the
steering wheel.
Move the lever to control the windshield wipers.
9 (Off): Turns the windshield wipers off.
& (Intermittent; Speed Sensitive Wipers): For
intermittent or speed sensitive operation. While in this
x
position, turn the band up or down to vary
frequency.
The amount of delay time varies between wiping cycles
due to the delay setting selected or the speed of the
vehicle. As vehicle speed is increased or decreased,
the wiper interval also increases or decreases.
4-5