Table of Contents
Advertisement
PWR/VOL (Power/Volume)
Push "PWR/VOL" to turn the audio sys-
tem on and off. Turn the "PWR/VOL" knob
to adjust the volume.
Pull out and then turn "PWR/VOL" to ad-
just the balance between the right and left
speakers. Move the "FADE" ring around
"PWR/VOL" to adjust the front/rear bal-
ance.
REW/FF (Rewind/Fast forward)
Push the "FF" side of the button to fast for-
ward a cassette tape. "FF" will appear on
the display. Push the "REW" side to re-
wind a tape. "REW" will appear on the dis-
play.
To stop the tape while it is fast forwarding,
push "FF" or "TAPE"; to stop the tape
while it is rewinding, push "REW" or
"TAPE". The tape will immediately begin
to play.
If a tape side rewinds completely, the cas-
sette player will stop and then play that
same side. If a tape fast forwards com-
pletely, the cassette player will play the
other side of the tape, using the auto-re-
verse feature.
94
WWW.MANUALS.WS
SCAN
You can either scan all the frequencies on
a band or scan only the preset stations for
that band.
To scan the preset stations: Quickly push
and release "SCAN". If you hear a beep,
you held the button too long, and the radio
will scan all the frequencies. The radio will
tune in the next preset station up the
band, stay there for a few seconds, and
then move to the next preset station. To
select a station, push "SCAN" a second
time.
To scan all the frequencies: Push "SCAN"
until you hear a beep. The radio will find
the next station up the station band, stay
there for a few seconds, and then scan
again. To select a station, push "SCAN" a
second time.
ST (Stereo reception) display
Your radio automatically changes to ste-
reo reception when a stereo broadcast is
received. "ST" appears on the display. If
the signal becomes weak, the radio re-
duces the amount of channel separation
to prevent the weak signal from creating
WWW.MANUALS.WS
noise. If the signal becomes extremely
weak, the radio switches from stereo to
mono reception.
TAPE
Push "Tape" to switch from radio opera-
tion to cassette operation. If the audio
system is off, you can turn on the cassette
player by pushing "TAPE". In both cases,
a cassette must already be loaded in the
player.
TREB (Treble)
This knob lets you adjust the treble level.
Push "BASS/TREB" so that it pops out of
its retracted position. Pull out the knob.
Turn the knob to adjust the treble. Push
the knob back into its retracted position.
TUNE
Tuning
Your Toyota has an electronic tuning radio
(ETR).
Push and release the " " (up) or " "
(down) side of "TUNE" to step up or down
the station band. If you hear a beep, you
held the button too long and the radio will
go into the seek mode.
Advertisement
Table of Contents
