Durabrand 5 CD Changer Home Stereo System Operating Instructions

PRECAUTIONS
Follow the advice below for safe and appropriate operations.
ON PLACEMENT
• Do not use the unit in places which are extremely
hot, cold, dusty, or humid.
• Place the unit on a flat and even surface.
• Do not restrict the air flow of the unit by placing
it in a place with poor air flow, by covering it
with a cloth, or by placing it on a carpet.
ON AC VOLTAGE
• Before use, check that the rated voltage of
your unit matches your local voltage.
FCC INFORMATION (FOR USA ONLY)
This device complies with Part 15 of FCC Rules.
Operations are subject to the following two
conditions:
(1) This device may not c a u s e harmful
interference, and (2) This device must accept
any interference received, including interference
that may cause undesirable operations.
SYSTEM CONNECTIONS
SPEAKERS CONNECTING
• Connect the wires to the speaker terminals in correct position.
• Connect speakers other than the speakers supplied with the unit may damage the unit.
AC POWER CONNECTING
• Before use, check that the rated voltage of your unit matches your local voltage. Make sure
speakers are connected correctly before plugging the AC power cord into an AC outlet.
CAUTION :
• Be sure the AC power cord is disconnected and all functions are off before making connections.
• TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY
INSERT (FOR USA AND CANADA ONLY).
FM ANTENNA
• Do not connect to an outside antenna.
PARTS IDENTIFICATION
1
2
3
4
5
6
7
8
9
10
11
1. CD door
2. POWER STANDBY indicator
3. VOLUME control
4. ON indicator
5. FM STEREO indicator
6. PHONES jack
7. FUNCTION switch (ST.BY/
TUNER/CD)
8. CD OPEN/CLOSE button
9. CD REPEAT ALL DISC button
10. CD REPEAT ONE/DISC button
GENERAL OPERATION
COMPACT DISC (CD) DISPLAY
1. REPEAT mode indicators
2. PROGRAM indicator
3. Playback indicator
4. Pause indicator
5.Disc indicator
6.Track indicator
ON SAFETY
• When connecting or disconnecting the AC cord,
grip the plug and not the cord itself. Pulling the
cord may damage it and create hazard.
• When you are not going to use the unit for
a long period of time, disconnect the AC power
cord.
ON CONDENSATION
• When left in a heated room where it is warm
and damp, water droplets or condensation may
form inside the CD player.
• When there is condensation inside the unit, the
unit may not function normally.
• Let it stand for 1 to 2 hours before turning the
power on, or gradually heat the room up and
dry the unit before use.
Should any trouble occur, disconnect the AC
power cord and refer servicing to qualified
personnel.
2
1
12
13
14
15
2
16
17
18
19
20
11. CD STOP button
12. CD display
13. TUNING control
14. Remote sensor (optional)
15. BAND selector (FM/AM)
16. Mode selector (FM.ST/FM MONO)
17. DISC SKIP button
18. CD SKIP/SEARCH buttons
19. CD PLAY/PAUSE button
20. CD STORAGE door
SOUND ADJUSTMENT
TO ADJUST THE VOLUME
Adjust the VOLUME control to obtain the desired volume level.
FOR PERSONAL LISTENING
Connect headphones ( Ø3.5mm stereo mini plug) to the PHONES jack.
Adjust the VOLUME for the desired listening level.
When headphones are connected, the speakers are automatically
disconnected.
RADIO OPERATION
1. Set the FUNCTION switch to TUNER.
3. Tune into a station.
RADIO OPERATION
FOR BETTER RECEPTION
Fully unwind the wire antenna. Then extend the
wire antenna and place it in the position that
sounds best.
NOTE:
DO NOT CONNECT FM ANTENNA WIRE TO
OUTSIDE ANTENNA.
FM
TO RECEIVE THE FM BROADCAST IN STEREO
Set the Mode selector to FM.ST.
When the FM STEREO broadcast is received, FM STEREO indicator lights up.
IF THE FM BROADCAST SIGNAL IS WEAK
Set the Mode selector to FM MONO position to turn off the FM STEREO indicator and background
noises become monaural.
AFTER LISTENING
Set the FUNCTION switch to ST.BY (Standby).
COMPACT DISC PLAYBACK
1. Set the FUNCTION switch to CD.
3. Press the DISC SKIP button to revolve the tray clockwise.
Place other disc(s) on the disc holder(s).
WARNING: Take out all discs from the disc tray before transportation.
4. Press the OPEN/CLOSE button to close the disc tray. It takes a short while for your player to check the
discs.
5. Press the DISC SKIP button to select the
desired disc. Press either one of the SKIP/
SEARCH buttons to select the desired track.
To stop playing:
a) For a moment only, press PLAY / PAUSE button and " " will be displayed. Press this button again
to resume playing.
b) Press CD STOP button.
NOTE:
• To locate a track of currently selected disc, press
• To locate a track of another disc, press DISC SKIP button to get to desired disc first and then
press or SKIP/SEARCH button repeatedly.
• To search a track, keep or SKIP/SEARCH button pressed and release it at desired point.
FORWARD
REVERSE
SKIP
PRESS IT REPEATEDLY
2. Select the desired band.
4. Adjust the volume.
Rotate the unit to get the best receiving position.
2. Press the OPEN/CLOSE button to open the disc
tray. Place the first disc onto the disc holder, with
the label side up.
6. Press PLAY/PAUSE button to start playback.
or SKIP/SEARCH button repeatedly.
REVERSE FORWARD
SKIP
SEARCH SEARCH
KEEP IT PRESSED
AM /
MW