CARL GOLDBERG 120 ARF Instructions Manual page 29

3. Mount the two flying wire brackets under the
front mounting screw of the tail wheel brack-
et.
Install the wheel collar with just the set screw
4.
on the axle bracket and insert through the
mounting bracket.
Install the two nylon pushrod fittings on the
ends of the two threaded rods. Screw the
threaded rods into the sides of the other
wheel collar
Install the assembly on the top of the axle
bracket and tighten the set screw. Make
sure the threaded rods are parallel with the
axle.
Place the wheel on the axle and secure with
5.
the wheel collar.
spring fitting
6. If you have not installed the pushrod fitting for
the tiller springs you will need to remove the
rudder cables and screw them in place.
Install the springs between the rudder horn
7.
and the tail wheel steering arm. Make sure
rudder is centered and tail wheel is straight
ahead.
29