CARL GOLDBERG 120 ARF Instructions Manual page 10

WING INSTALLATION ON FUSELAGE
1. Collect the following items:
(1) Right wing
(1) Left wing
(2) 8mm x 36mm aluminum dowel
(1) Large aluminum tube
(1) Small aluminum Tube
(2) 1/4-20 x 2" nylon bolts
(2) Plywood reinforcement plate
NOTE: If the covering on your wing has loosened
in transit, refer to the covering section of
the "INTRODUCTION" before continuing.
2. Using epoxy, mount the 8mm x 36mm alu-
minum dowels into the holes in the leading
edge of the wing. Make sure to leave about
1/2" of dowel sticking out of the front of the
wing. You may wish to slightly taper the
exposed dowel ends for ease of insertion into
the fuse holes.
3. Insert the large aluminum tube into one wing
half and push the tube into the wing until it
stops. Then insert the small aluminum tube
into the small hole till it stops. Then slide the
wing halves together.
Insert the wing into the wing saddle of the
4.
fuselage by sliding the dowels in the front of
the wing into the holes in the former just for-
ward of the wing saddle.
Align the holes in the wing bolt plate over the
holes in the wing. Insert the 1/4x20 bolts and
tighten.
10