Table of Contents
Advertisement
Main Menu
2.
Put your fingers under the front
edge of the hood to the right of
center. Slide your hand to the left
until you feel the hood latch
handle. Push this handle to the left
to release the hood. Lift up the
hood.
Table of Contents
If the hood latch handle moves
stiffly, or you can open the hood
without lifting the handle, the
mechanism should be cleaned and
lubricated.
3.
Pull the support rod out of its clip
LATCH
and insert the end into the square
HANDLE
hole on the right side of the hood.
HOOD
Service Station Procedures
SUPPORT ROD
To close the hood, lift it up slightly to
remove the support rod from the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a foot (30 cm) above the
fender, then let it drop. Make sure it
is securely latched.
109
Advertisement
Table of Contents
