Electrical Connection - John Lewis JLWFF1552 Instruction Manual

Electrical connection

Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
WARNING: THIS APPLIANCE MUST
BE EARTHED.
Should the appliance power supply
cables need to be replaced, this must be
carried out by a Service Force agent
(see page 22)
The manufacturer declines any liability
should this safety measure not be
observed.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the
appliance's rating plate. (See picture on page 5).
The appliances are supplied with 3 x 13amp
independent plugs.
In the event of having to change the fuse in the plug
supplied, a 13amp ASTA approved BS 1363/A fuse
must be used.
Should the plug need to be replaced for any reason,
proceed as described below.The wires in the mains
lead are coloured in accordance with the following
code:
Green and Yellow
Blue
Brown
If you fit your own plug, the colours of the wires in
the mains lead of your appliance may not
correspond with the markings identifying the
terminals in your plug.
6
- Earth
- Neutral
- Live
Proceed as follows:
1. Connect the Green and Yellow (earth) wire to the
terminal in the plug which is marked with the letter
"E"or the earth symbol
yellow.
2. Connect the Blue (neutral) wire to the terminal in
the plug which is marked with the letter "N" or
coloured black.
3. Connect the Brown (live) wire to the terminal in
the plug which is marked with the letter "L" or
coloured red.
4. Upon completion there must be no cut, or stray
strands of wire present and the cord clamp must
be secure over the outer sheath.
WARNING: A cut off plug inserted into
a 13 amp socket is a serious safety
(shock) hazard.
Ensure that the cut off plug is disposed
of safely.
The plugs must still be accessible after
the appliance has been installed.
The appliance should not be connected
to the electrical supply by means of an
extension cable.
or coloured green and