King Canada 8449N Instruction Manual

King Canada 8449N Instruction Manual

King canada 1.5 hp air compressor

Advertisement

1.5 HP AIR COMPRESSOR

INSTRUCTION MANUAL

COPYRIGHT © 2010 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
KING CANADA
MODEL: 8449N
performance
performance
plus
plus

Advertisement

Table of Contents
loading

Summary of Contents for King Canada 8449N

  • Page 1: Instruction Manual

    KING CANADA 1.5 HP AIR COMPRESSOR performance performance plus plus MODEL: 8449N INSTRUCTION MANUAL COPYRIGHT © 2010 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
  • Page 2: Warranty Information

    LIMITED TOOL WARRANTY King Canada makes every effort to ensure that this product meets high quality and durability standards. King Canada warrants to the original retail consumer a 2-year limited warranty as of the date the product was purchased at retail and that each product is free from defects in materials.
  • Page 3: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS RISK OF EXPLOSION OR FIRE HOW TO PREVENT IT WHAT CAN HAPPEN Always operate the compressor in a well ventilated area free of It is normal for electrical contacts within the motor and pressure combustible materials, gasoline or solvent vapors. If spraying switch to spark.
  • Page 4: Specifications

    SPECIFICATIONS & ELECTRICAL INFORMATION SPECIFICATIONS Model......................................8449N Voltage......................................120V Horsepower ......................................1.5 Amperage......................................12.5A RPM (no load speed) ..................................3400 Phase ........................................1 Hertz ......................................60Hz Operating pressure ..................................115 PSI CFM @ 40 PSI ....................................2.76 CFM @ 90 PSI ....................................2.30 Tank size ....................................2 Gallon WARNING ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE COMPRESSOR DISCONNECTED FROM THE POWER SOURCE.
  • Page 5 ASSEMBLY & OPERATION CONTROLS ASSEMBLY OF THE AIR COMPRESSOR Your compressor comes almost completely assembled. 1) Install the muffler (A) Fig.3 to the cylinder cover (B) by screwing it into place as shown. 2) Remove the plastic cap (A) Fig.4 and replace it with the oil breather cap (B) by screwing it into place as shown. 3) It may be necessary to install the pressure gauges (A and B) Fig.5, place Teflon®...
  • Page 6 OPERATION CONTROLS & BREAK-IN PROCEDURES OUTLET PRESSURE GAUGE (E) FIG.6. The outlet pressure gauge indicates the air pressure available at the outlet side of the regulator. The pressure is controlled by the regulator and is always less than or equal to the tank pressure. TANK PRESSURE GAUGE (F) FIG.
  • Page 7 OPERATION, MAINTENANCE & STORAGE OPERATING PROCEDURES Preparation for use: 1) Before attaching air hose or any accessory, make sure the pressure switch lever is set to “OFF” and the pressure regulator is closed. 2) Install air hose male coupler into the female quick connect (C) Fig.5 on the air compressor, to do this, push quick connect collar backwards and hold it in this position.
  • Page 8: Troubleshooting

    Drain crankcase and fill to proper level Compressor overheated Air pressure regulated too high Restricted air filter Replace filter PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.

This manual is also suitable for:

8488nPerformance plus 8449n

Table of Contents