Table of Contents
Advertisement
Filling the System
Use the following procedure to fill the internal ink and replenisher tanks of
the 7122 printer:
1. Connect the good ink and replenisher supply containers.
Note: Leave the cabinet open to check for leaks.
2. Power up the printer with the fluid system bypassed.
3. Go to Circulate Table state 3 to fill the tanks.
4. When the tanks are full, go to Circulate Table State 6 for 15 minutes.
This is a diagnostic circulate state.
5. Go to Printhead Down.
6. Change State Table type back to Normal.
7. Bring the system through a Normal Up and Printhead Shutdown
cycle.
8. Power off the printer.
9. Repeat step 3 through step 6 of the "Filling the System" procedure
and then skip to step 10.
10. If you are going to resume production, bring the printer through a
Normal Up to Ready.
Note: Normal Up = bypassed fluid system. Use the Standby button to bring the
printer to Ready.
Ink and Replenisher Procedures
Filling the System
21
Advertisement
Table of Contents
