Bike Assembly
NOTE: If your Expresso bike was delivered with white glove
service, please skip this section and go to page 5 for Bike
Installation.
Two people are required to unpack and assemble the Expresso
bike.
Prepare to unpack the bike
The S3 Upright Bike package includes:
◦
The Expresso S3u or S3y bike
◦
AC power cord
◦
User Guide
◦
Assembly and Installation Guide (this guide)
◦
Hardware kit
Left side socket head cap with washer, center button
cap screw, right side socket head cap with washer,
5mm Allen wrench, 6mm Allen wrench
The following equipment is required to unpack and assemble the
S3 bike:
◦
Wire snips
◦
Knife or scissors
◦
2 dollies
Unpack and assemble the bike
1. Remove outer packaging from the bike.
CAUTION: Use scissors or a knife to cut plastic film. Avoid
cutting the film against bike to avoid damage. The following
image shows how the bike is placed under the wrapper. Read
all instructions before proceeding.
2. Remove only the top foam pad covering the monitor.
3. Remove the protective shipping bracket.
WARNING: It is important to discard the shipping bracket
and all 4-hinge bracket bolts immediately after taking them
off the bike. NEVER reuse the hinge bracket or the 4-hinge
bracket bolts at any time during the assembly and
installation of the bike.
a. Remove screws by using a 6mm Allen wrench.
b. Remove the shipping bracket carefully. If it does not come
off easily, use the plastic tie and lift the bracket.
Interactive Fitness Holdings
3