Indoor Unit; Cutting A Hole And Mounting Installation Plate - Toshiba RAS-13SK-E Service Manual

8-4. Indoor Unit

t Installation place
• A place which provides the spaces around the in-
door unit as shown in the diagram in section 8-2.
• A place where there is no obstacle near the air in-
let and outlet.
• A place which allows an easy installation of the pip-
ing to the outdoor unit.
• A place which allows the front panel to be opened.
CAUTION
• Direct sunlight to the indoor unit wireless re-
ceiver should be avoided.
• The microprocessor in the indoor unit should
not be too close to r-f noise sources. (For de-
tails, see the owner's manual.)
<Remote control>
• A place where there are no obstacles such as a
curtain that may block the signal from the remote
control.
• Do not install the remote control in a place exposed
to direct sunlight or close to a heating source, such
as a stove.
• Keep the remote control at least 1 m apart from
the nearest TV set or stereo equipment. (This is
necessary to prevent image disturbances or noise
interference.)
• The location of the remote control should be deter-
mined as shown below.
Remote
Reception
control
range
(Top view)
Indoor unit
Reception
range
*:Axial distance
Fig. 8-4-1
8-4-1. Cutting a Hole and Mounting
<Cutting a hole>
When installing the refrigerant pipes from the rear
The center of the pipe
hole is the above arrow.
(1) After determining the pipe hole position with the
mounting plate (80 mm →), drill the pipe hole (ø65
mm) at a slight downward slant to the outdoor side.
NOTE :
• When drilling the wall that contains a metal lath,
wire lath or metal plate, be sure to use a pipe hole
brim ring sold separately.
<Mounting the installation plate>
For installation of the indoor unit, use the paper pat-
tern on the back.
65.5mm
Pipe
hole
Remote
control
– 22 –
Installation Plate
The center of the piping slot
is the above arrow.
Pipe hole
80mm
Fig. 8-4-2
Anchor bolt hole
Thread
Indoor unit
Weight
Fig. 8-4-3
65.5mm
1
Pipe hole
Installation
plate
8 Mounting
screw