Installation Diagram - Jobsite V-12/AWE Installation & User Manual

6. Use a small flathead screwdriver or your thumb to
raise the locking tabs, exposing the holes on the
connector.
7. Insert each wire into the appropriate hole and
snap down the locking tabs.
8. Insert the smooth side of the connector plug into
the smooth side of the V-12/AWE socket.
9. Install the V-12/AWE into the all-weather
enclosure.
10. Set the Impedance Magnification Switch as
determined by the impedance charts.
11. Set the switches, on all of the controls, to the
same position (1x, 2x, 4x, or 8x).
12. Attach the cover plate.
See installation diagram.

INSTALLATION DIAGRAM

Input From
Amplifier
V-12/AWE
Side View
Output to
Speakers
Stereo Receiver
Speakers
V-12/AWE
5