Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Dot-x DNR V SERIES
Summary of Contents for Dot-x DNR V SERIES
- Page 1 DNR V SERIES Handheld Addressable Remote Control 160 FIRST STREET S.E. ST. PAUL, MN 55112-7894 PHONE 651-633-1742 FAX: 651-633-1065 www.dotronix.com User’s Manual Publication No. 01084 Rev A...
- Page 2 PRECAUTIONS This remote control contains circuits and components designed to meet Dotronix Limited Warranty specific performance and safety requirements. No component changes may be made without the written permission of the manufacturer. Dotronix warrants that for one (1) year from date original purchase, it will, at its option, repair, replace or refund the purchase price of any product which it manufactured that proves defective in material or workmanship in normal use and service.
-
Page 3: Getting Started
INDEX INTRODUCTION Congratulations on your purchase of a new DNR V Series with HARC AVAILABLE MENUS (Handheld Addressable Remote Control) option. BASIC MENU OPERATION CHANGING SECURITY CODE AND UNIT NUMBER This manual has been prepared to act as a guide in the operation of your unit CHECKING REVISION LEVEL when the HARC option is installed. -
Page 4: Custom Options
TO ACTIVATE MENUS AND CONTROLS CUSTOM OPTIONS Stand in front of the unit (monitor) and aim the remote at the InfraRed (IR) LOST OR FORGOTTEN SECURITY CODE receiver located on the lower right corner of the unit. Press and hold the ENTER key on the remote for several seconds (typically 6 to 8 seconds). - Page 5 CUSTOM OPTIONS TO ACTIVATE MENUS AND CONTROLS Pressing the ENTER key saves the displayed times and as the new Start The following on screen display (OSD) will appear. and Stop times. After pressing the ENTER key the On Screen Display is erased until THIS UNIT SELECTED another selection is made via the remote control.
-
Page 6: Remote Control
CUSTOM OPTIONS REMOTE CONTROL The following has been prepared to act as a guide in the operation of your Press and hold the 6 (six) key until the following screen appears REMOTE CONTROL input equipped monitors. Please read the following (typically 6-8 seconds). -
Page 7: Available Menus
HARC MENU AVAILABLE MENUS Your monitor is menu operated. In other words, adjustments to the monitor are If you have changed the unit number from the factory setting, the current made via a list of choices which appear on your monitor screen. To view these number will appear where the 01 is shown above. - Page 8 HARC MENU INSTALLERS MENU ADJUSTMENTS CHANGING SECURITY CODE AND UNIT NUMBER To access the Installer’s Menu, press and hold the MENU key until the User Menu display disappears, then press 9876, (this may take a couple tries) and then The security code and the unit number can be changed with the remote control. ENTER to access the Installer’s Menu.
- Page 9 INSTALLERS MENU ADJUSTMENTS INSTALLERS MENU ADJUSTMENTS 03 POWER MANAGE: Range is 0-7. 1-7 is the length of time (in hours) that the 58 AUTO CAMPORT: Enable Camport sense. When in 1 Camport sense is set will continue to operate if unattended. When the set nears turn off time, an on- enabled and when Camport connector plug is detected the display will change to screen message appears telling you to press any key to continue normal viewing.
- Page 10 INSTALLERS MENU ADJUSTMENTS INSTALLERS MENU ADJUSTMENTS scan. In scan modes 1,3 the power On/Off could be changed with Start Ch SM=1 35 RF AGC: (Rf Automatic Gain Control) Range is from 0- 63. 48 is a general Factory items and Start channel. setting.
Need help?
Do you have a question about the DNR V SERIES and is the answer not in the manual?
Questions and answers