Hardware Controls & Analogue Inputs - Philips Dynalite DLE220-S Installation Manual

hardware controls
AUX Input - This is a dry contact interface that is active low. The dry contact is connected
between the AUX and GND terminals on the DyNet connector strip. The function of the AUX input
is programmable. Ensure that the cable length between the dry contact and terminal strip is no
longer than 2 metres.
Service LED - The Service LED has 3 signalling modes, which are useful for troubleshooting:
Blinking slowly (1Hz) = Normal Operation
Blinking fast (4Hz) = Network Activity Detected
On = Fault
Service Switch - The Service Switch has three functions:
1 push = Transmit Network ID
3 pushes = All Channels 100%
Push & hold for 4 sec = Reboot
Accessory Module Socket - Accepts plug in modules for optional features such as DMX512
ports. Consult your distributor for details on the available accessory modules.
7
DLE220-S Instruction Manual Rev F.doc