Operating Instruction - Puch Magnum II MKII Owner's Manual

E) OPERATING INSTRUCTION
1.
Prop the moped on its stand .
2. Unlock fork.
3. Magnum MK II only. Turn on ignition - 1st step to the right
on the switch .
4. ·Turn fuel valve to the ON position.
5. Be sure that the engine stop switch is in the RUN position.
6. If engine is cold , depress the choke and depress the primer
button on the carburetor until fuel drips from carburetor.
CAUTION: After completing step 6 do not open the throttle
control, as this will deactivate the choke . After the engine
has started and warming up, open throttle gently to the full
position briefly. This will disengage choke . Avoid racing
engine.
7. Keep both hands on the handlebar with the weight of the
moped centered on the front wheel. Apply the front brake and
fully depress the starting lever located on the left side of the
handlebar. Position the pedal approx. parallel to the chain
guard. While holding the starter lever, push the pedal to start
engine.
8. Alternate starting method:
The moped may also be started by pedalling as a bicycle.
When momentum has been gained , pull the start lever and
gently open the throttle. Release the start lever after the
engine starts.
1
17