Procedure 6.2 - Replacing The Lift Platform - Precor C966 Serivce Manual

Procedure 6.2 — Replacing the Lift Platform
1. Set the treadmill circuit breaker in the "off" position. Remove the AC line cord from the AC
outlet.
2. Remove the treadmill hood. Carefully, lay the treadmill on it's right side.
3. Remove the hitch pin and clevis pin that fastens the lift motor tube to the lift platform. While
the lift tube is not fastened to the lift platform, care must be taken to not allow the lift tube to
rotate. If the lift tube rotates, the lift motor must be re-calibrated per Procedure 4.1.
4. Remove the lift platform retaining bolt from both the left and right hand side of the lift
platform. See diagram 6.1.
Diagram 6.1 - Lift Platform Mounting)
Lift
Platform
Alignment
Hole
5. Slide a 5/32 inch allen wrench or similar slender tool into the alignment hole as shown in
Diagram 6.2. Pull the right hand (lower) lift pin out of the treadmill frame.
C966 Treadmill
Retaining B
Retaining
Bolt
Lift Pin
Page 32