Pana-Pacific Blue Eagle ll Instruction Manual page 6

3. Before pairing, ensure that the Blue Eagle II is turned off.
4. Press and hold down the multi-function button on the headset for
about 5-10 seconds. You will hear a series of tones in the earpiece
and the blue indicator on the headset will flash rapidly. When you
hear the tones, release the multi-function button.
5. Refer to the User's Manual of your other Bluetooth device for
instructions on how to pair the other Bluetooth device to the headset
and follow the instructions on the device screen. When prompted,
select "BE II" from the list. Enter the pre-programmed passcode
"0000" and press "OK".
6. Now the blue indicator light on the Blue Eagle II headset stops
flashing, pairing has been completed (consult the user manual of
your other Bluetooth device for pairing confirmation indicators). The
blue indicator light on the headset will flash slowly, about every 5
seconds, indicating that headset is now in Idle Mode.
If the pairing cannot be completed within 2 minutes, or the blue indicator
light flash rapidly, please repeat steps #1 to #6 to pair again.
HEADSET VOLUME AND MUTE CONTROLS
Adjust Earpiece Volume
To adjust the volume in your earpiece, do short clicks using the Volume
Up (+) or Volume Down (-) button. Repeat until volume is at desired level.
You may also be able to adjust speaker volume on your other Bluetooth
device (such as a wireless phone). Check the owner's manual for the
other Bluetooth device for more information.
Mute the Microphone on the Headset
To mute the microphone, press and hold down the Volume Up (+) button
for 4 seconds. You will hear ascending beeps in two tones and the
microphone will be muted. A beep will be heard periodically indicating
that the microphone is in Mute Mode. This will not be heard by the other
person on the call.
Un-Mute the Microphone on the Headset
To un-mute the microphone, press and hold down the Volume Up (+)
button for 4 seconds. You will hear descending beeps in two tones and
the microphone will un-muted.