Using The Element Manager; Element Manager Workstation Requirements - McDATA Eclipse 2640 SAN Administration And Configuration Manual

Using the Element Manager

Workstation
Requirements
Table 2-1

Element Manager Workstation Requirements

Operating system
Java Runtime Environment
Management Platform
9. Reset the system using the following command:
reset system
The management IP address is now set and ready for normal
operation.
10. If you require a terminal connection to the 10/100 port for
out-of-band management, connect the standard RJ45 Cat 5
Ethernet cable from the LAN to the management port.
11. Ping the IP address that you entered for the SAN Router to verify
network connectivity using the network management host.
If there is no ping response, contact your network administrator
to set up connectivity between the network management station
and the SAN Router.
The Element Manager is a web-based Java applet used to configure,
monitor, and troubleshoot individual SAN Routers. The software is
embedded in every SAN Router, so it does not need to be installed as
a separate program on the management workstation for your mSAN.
Before you begin using the Element Manager, make sure that your
workstation meets the requirements described in this section, that
your browser is set up, and that you review the provided tips.
Workstation requirements for the Element Manager are listed in the
following table:
IBM Compatible Intel Pentium Class PC, 400
MHz or above with mouse, 32-bit
a
Windows 2003 Server Enterprise Edition
Windows 2000 with SP4
Windows XP with SP2
JRE 1.5 and higher (provided with
SANvergence Manager)
None required

Using the Element Manager

Sun Ultra 5 or better; 300 MHz or above, with
mouse
Solaris 9.0 and Solaris 10.0. Refer to
www.sun.com
JRE 1.4 and later (not provided with
SANvergence Manager)
None required
Configuring System Basics
2
2-5