Advertisement
BLACK BOX
7. How to Install
1) Install the Urive single HD SD card to the main device.
2) Select a location for attaching the main device.
3) Clean the area on the windshield where the product is to be installed.
4) Remove the cover sheet from the adhesive tape on the holder.
5) Affix the Urive single HD at the desired position.
6) Connect the B+, ACC lines to exact port. (if it is not correct, the device is damaged and not
working normally)
- 3-lines installation : Red (B+,BAT)/ yellow(ACC+)/ black(ground, GND-)
7) After finish the cable installation, Connect the main power cable(cigar cable) to the DC port.
8) The LED will be turned on after the power switch is "ON" and then the device is started with
information voice. .(Before finishing, please check the front/rear views are normally recorded
and stored)
9) After booting, the RED LED will be turned on and start recording.
10) The camera's shooting angle can be adjusted on the screen when the Video cable is connected
to navigation AV-IN or CAM terminal.
11) After adjusting the camera's shooting angle, please fastened the device on the holder.
12) If users install the GPS, please make sure the power off before installing.
※ Caution
- Before placing the cables in the groove, please check the video images are normally stored
in the memory card.
- After installing the camera, remove the protective plastic film from the camera lens.
- When the device is parking mode, the BLUE LED is turned on and switch to parking mode
voice information is out and motion detection function is working.
URIVE ACE
Advertisement
