Advertisement
Meitav-tec Ltd (Contel group)
Tel: +972 (3) 962 6462 Fax: +972 (3) 962 6620
www.meitavtec.com - support@meitavtec.com
RT03 - Hand Held Remote Control
Operating manual
Please read this manual carefully before use.
Index
General
On/Off
Fan Speeds
1. General
This is an Infra red Remote Control Unit, which means it must be pointed at the
thermostat (or extra receiver) to operate.
Every time you change a parameter in the Remote Control, you must send it to
the thermostat by pressing the "ON/SEND".
2. On/Off
• Press the ON/SEND button to activate the air conditioner / fan
coil unit and/or updating information.
3. Fan Speeds
• Press the FAN button to switch between fan speeds:
High Speed
Medium Speed
Low Speed
Auto Speed
• Press the ON/SEND button to send information to thermostat.
File: rt03.doc
- 1 -
1
2
3
4
5
6
7
8
Rev. 1, May 4, 2005
Advertisement
Table of Contents
Related Manuals for meitav-tec RT03
Summary of Contents for meitav-tec RT03
- Page 1 Meitav-tec Ltd (Contel group) Tel: +972 (3) 962 6462 Fax: +972 (3) 962 6620 www.meitavtec.com - support@meitavtec.com RT03 - Hand Held Remote Control Operating manual Please read this manual carefully before use. Index General On/Off Fan Speeds Modes Temperature Set-Points...
- Page 2 • Adjust the minutes using the (+) or (-) buttons. • Press the SELECT again to return to normal display mode. • Press the ON/SEND button to send information to the thermostat. File: rt03.doc - 2 - Rev. 1, May 4, 2005...
- Page 3 • Adjust the hours using the (+) or (-) buttons. • Press the SELECT button - the minutes will flash. • Adjust the minutes using the (+) or (-) buttons. File: rt03.doc - 3 - Rev. 1, May 4, 2005...
- Page 4 Install two new AAA batteries – Pay attention to the polarity. Return the batteries cover to place. Important: The remote control will not operate unless at least 10 minutes pass between removing the old batteries and installing the new ones. File: rt03.doc - 4 - Rev. 1, May 4, 2005...
Need help?
Do you have a question about the RT03 and is the answer not in the manual?
Questions and answers