meitav-tec RT40 Owner's Manual

Infra Red Remote Control
Timer
Active
Not active
Modes display
Heat
Cool
Turn system OFF
Clock adjustment
Turn system ON
/ Send changes
Tel: +972-3-9626462
Fax: +972-3-9626620
support@meitavtec.com
RT40
Clock
Temperature scale
°C
Set-point display
Fan speeds display
Low
Medium
High
Auto
Mode selection
Set-point adjustment
Timer and Real Time Clock and Day
Timer Start Time
Press the [Select] button – "PROGRAM & START" will flash on display.
Press the [+] button - the hours will flash.
Adjust the hours using the [+] or [-] buttons.
Press the [Select] button - the minutes will flash.
Adjust the minutes using the [+] or [-] buttons.
Timer Stop Time
Press the [Select] button again – "PROGRAM & STOP" will flash on display.
Press the [+] button - the hours will flash.
Adjust the hours using the [+] or [-] buttons.
Press the [Select] button - the minutes will flash.
Adjust the minutes using the [+] or [-] buttons.
Press the [Select] button - the TIMER will blink
Select TIMER ON (black icon) or OFF (white icon) using the [+] or [-] buttons.
Clock
Press the [Select] button again – "CLOCK SET" will flash.
Press the [+] or [-] buttons - the hours will flash.
Adjust the hours using the [+] or [-] buttons.
Press the [Select] again - minutes will flash.
Adjust the minutes using the [+] or [-] buttons.
Press the [Select] again to return to normal display.
Press the "On/Send" button to send information to the thermostat.
Batteries Replacement
When the batteries are low, the display of the remote control will dim.
If the batteries will not be replaced the display will turn off completely.
Batteries replacement:
Pull the batteries cover down to reveal the batteries.
Remove the old batteries.
Wait for 10 minutes before installing the new batteries.
Install two new AAA batteries – Pay attention to the polarity.
Return the batteries cover to place.
Important: The remote control will not operate unless at least 10 minutes pass
between removing the old batteries and installing the new ones.