Speaker Output - JL Audio J2250.1 Owner's Manual

sPeaKer outPut

Speaker connection to the J2-250.1 is
straightforward and takes place at the far
right of the power/speaker connection
panel. Two positive ("+") connections and
two negative ("–") connections are available
via a connector labeled "Speaker Output
(Mono)". The dual connections allow for two
separate speaker wire runs to be parallel-
connected to the amplifier's mono output.
Speaker Output (Mono)
!
IMPORTANT
Speaker loads below 2Ω nominal are not
recommended and will cause the amplifier to
enter into a protection mode.
Do not chassis ground any speakers connected
to this or any other JL Audio amplifier. Doing so
will cause the amplifier to go into protection.
To connect the speaker wires to the amplifier,
strip 1/2-inch (12 mm) of insulation from
each speaker wire and insert them into their
appropriate connector (observing correct
polarity). Then, tighten each connector using a
Phillips screwdriver.
10
!
IMPORTANT
Do NOT attempt to "bridge" two J2-250.1's
together or combine their output to a single
load in any manner. Doing so will damage the
amplifier(s).
!
IMPORTANT
Before reconnecting the battery ground and
turning the system on, verify that all control
settings on the amplifier are set according to
the needs of the system.
JL Audio