Desa LMFP33NR Owner's Operation And Installation Manual page 18

INSTALLATION
Continued
4. Place left top log on left pins on logs 2 and 3,
resting it on log 1 (see Figure 28).
5. Place right top log on right pins on logs 2 and
3 (see Figure 28).
6. Install fireplace screen by slipping notches of
fireplace screen over screws on front of fire-
place (see Figure 29).
WARNING: You must oper-
ate this fireplace with the fire-
place screen in place. Make sure
fireplace screen is in place be-
fore running fireplace.
Left Top Log
Figure 28 - Installing Logs 4 and 5
Notches
Screws for Mounting Screen
Figure 29 - Installing Fireplace Screen
18
INSTALLING BATTERIES FOR
REMOTE RECEIVER AND HAND
HELD REMOTE CONTROL
Four AA batteries and three AAA batteries are re-
quired to operate this heater with the wireless hand-
held remote control set. Four AA batteries must
be installed in the receiver and three AAA batter-
ies in the hand-held remote control unit.
Note: Only use alkaline batteries.
Installing Batteries in Receiver
1. Locate slot on battery cover of receiver (see
2. Insert 4 AA batterines into receiver. Positive
3. Slide tab on cover into receiver housing and
4 AA Batteries
Right Top Log
Installing Battery into Remote
1. Remove remote cover (see Figure 31).
2. Insert 3 AAA batteries into remote control (see
3. Slide remote cover back into place.
Figure 31 - Installing Batteries in Remote
www.desatech.com
Figure 30). Firmly insert tool such as a small
screwdriver, butter knife, or dime into the slot
and lift up to remove cover.
and negative are marked inside receiver cas-
ing. Note: Receiver will not function if bat-
teries are not installed correctly.
snap cover back into place.
Battery
Housing
Backup Switch
Figure 30 - Installing Batteries in
Receiver
Figure 31). Positive and negative are marked in-
side remote control casing. Note: Remote will
not function if batteries are not installed correctly.
3 AAA Batteries
Cover
Control
Slot Cover
Receiver
Remote
Control
111604-01E