Related Manuals for Figure Engineering 04 CHEVY COLORADO GRILLE SET
Summary of Contents for Figure Engineering 04 CHEVY COLORADO GRILLE SET
- Page 1 Figure Engineering 9208 Venture Ct – C9 Manassas Park VA 20111 Info@FigureLLC.com www.FigureEngineering.com Installation Manual 04 CHEVY COLORADO FIGURE GRILLE SET...
-
Page 3: Tools Required For Installation
Dear Customer, Thank you for purchasing Figure’s 2004-Present Chevrolet Colorado Grille Set. These grilles are fabricated employing quality materials and finishes, and have been engineered to enhance the look of your vehicle for the duration of its life. Proper installation is essential to your overall satisfaction, so please read these instructions before attempting to install the grilles. - Page 4 Chevy Colorado Grille Installation 1) Factory Grille Removal 1.1) Remove the upper bumper cover. The upper bumper cover of the Colorado holds the factory grilles and will need to be removed. It is held in place by 11 clips (locations shown in Fig. 1) and there are no tools needed to remove it.
- Page 5 modifying it for use with nylon ties). Using a flat-head screwdriver, pry between the top of the factory grille and the bumper (see Fig. 2). Using this method, you will break enough of the tabs so that you can finish pulling the grille away with your hands.
- Page 6 Fig. 3a – Location of holes (detail a) Fig. 3b – Location of holes (detail b) Fig. 3c – Location of holes (detail c) Fig. 3d – Location of holes (detail d)
- Page 7 2.2) Secure Figure Grilles Place a grille in its respective location, and feed nylon ties through the drilled holes and closest loop. Loosely fasten each tie, position the grille and then tighten each tie tightly. Finish by cutting the tails of the ties off. 2.3) Install Assembled Bumper Cover Position each clip of the bumper cover in its respective hole...
- Page 8 Fig. 4 – General location to drill 1/8” hole pairs for lower center grille. 3.5) Secure lower grille. Secure lower grill in place with the provided nylon ties. For each set of holes, lace a tie through the first opening, then through the grille, and then back through the second opening and finally tighten in place.
- Page 9 5) Replace Lower Bumper Cover 5.1) Reverse Steps of Removal After installing the lower grilles, replace the lower bumper cover by reversing the steps from 3.1 through 3.3. Fig. 6 – Send pictures and feedback to Info@FigureLLC.Com...