Table of Contents
Advertisement
TCP/IP control panel and the DNS fields on the One Page Setup, you can open
your browser to establish a connection to the Internet.
6.3.2 Static Configuration
To make changes to the WAN IP Address fields, connect to the One Page Setup
and complete the following:
1.
Select Specify an IP Address.
2.
Enter the static IP address provided by your ISP in the field located
immediately to the right of Specify an IP Address.
3.
Enter the Public Subnet Mask provided by your ISP.
4.
In the Default Gateway IP Address field, enter the information provided by
your ISP. Note that it may refer to "Gateway / Router IP Address." Also, note
that this number is not the same as the IP Address value that you have
entered in step 2.
5.
Enter the DNS information provided by your ISP in the Domain Name Server
fields. It should provide at least two unique DNS numbers.
6.
Click Apply to save your changes.
7.
Use your browser to establish an Internet connection to a website.
Note: If you experience any troubles, please refer to our Troubleshooting and FAQ
section.
6.3.3 PPPoE
Dynamic PPPoE Configuration
The PPPoE section on the One Page Setup takes the place of your ISP's
proprietary software such as MacPoET, WinPoET and EnterNet 300. This
software is limited to only a direct connection with the modem and will not be used
with our XRouter Aero. Major PPPoE ISPs include PacBell, Bell Atlantic,
Earthlink/Mindsrping, Southwestern Bell, Bell South and Bell Sympatico
(Canada).
The XRouter Aero can dynamically obtain a WAN IP Address from the ISP so
there is no further configuration needed than the PPPoE section. Although, we
suggest inputting the DNS numbers into both the TCP/IP control panel of the
computer and the DNS fields on the One Page Setup screen. If you do not have
these DNS numbers, you can obtain them from your ISP.
Proceed with the following steps to configure the XRouter Aero for a PPPoE
connection.
Figure 16
Advertisement
Table of Contents
