Table of Contents
Advertisement
Figure 5-2
Mount Bracket
Shield
5-2 OPTIONAL FRONT SHIELDING
INSTALLATION
(SQ 420, 480, 600, 720, 840)
A. Install front belting to deck lip angle securing
with 3/8 x 1-1/4" bolts, flatwashers and locknuts.
(SQ184 uses 3/8 x 3-1/2" bolts) Bolt heads should
be to the outside of the deck. (Figure 5-3)
Figure 5-3 Front Belting
3/8 x 1-1/4" Bolts
5-3 OPTIONAL FRONT SHIELDING
INSTALLATION (SQ84T)
A. Install front shield to deck lip angle securing
with six 3/8 x 1-1/4" carriage bolts, flatwashers, lock-
washers and nuts. (Figure 5-4) Carriage bolts should
be installed from top of lip angle.
B. Install right and left side shield to skid using
two 3/8 x 1-1/4" carriage bolts, flatwashers, lock-
washers, and nuts.
Figure 5-4 SQ84T Front Shielding
Side Shield
Skid
3/8 x 1-1/4" Carriage Bolts
Breather
Plug
8mm x 1-1/4" Bolt,
Lockwasher& Flatwasher
3/8 x 1-1/4" Bolt, Flatwashers
& Locknut (Each Side)
Lip Angle
Front Shield
Underside of Deck
5-4 OPTIONAL REAR BAND INSTALLA-
TION (SQ142, 148, 160, 172, 184)
CUTTER MUST BE EQUIPPED WITH FRONT
AND REAR BANDS WHEN OPERATING IN
THE VICINITY OF HIGHWAYS OR IN ANY
AREA WHERE PEOPLE MAY BE PRESENT
A. Align deflector band with holes in rear band of
deck.
B. SQ142 & 148 use the same fasteners in all
locations around the rear band. Fasten with 3/8 x 1"
capscrews, flatwashers, lockwashers and nuts.
(Figure 5-5)
SQ160, 172, & 184 require longer bolts at the outer
ends of the rear bands. Fasten the ends with 3/8 x
1-1/2" capscrews, flatwashers, lockwashers and
nuts. The remaining locations around the band use
3/8 x 1" capscrews, flatwashers, lockwashers and
nuts.
Figure 5-5 Rear Band
5-5 FRONT AND REAR CHAIN
INSTALLATION
Install chain sections in the same manner as the
front belting and rear bands. The rear safety chains
use only one bolt at each end.
Figure 5-6 Front Chain Assembly
Figure 5-7 Rear Chain Assembly
16
WARNING
Rear Band
3/8 x 1" Capscrews
Hide quick links:
Advertisement
Table of Contents
