Installation Questions?
Log on anytime to
www.icdynamics.com
or Call 800-624-0500
9 am.– 5 pm.
Monday – Friday
RS125
122706
Central time
IC DYNAMICS
8
IC DYNAMICS
REMOTE CONTROL CAR STARTER
INSTALLATION INSTRUCTIONS
With Keyless Entry and Power Trunk Release
WARNING
This Remote Car Starter is for vehicles with automatic trans-
missions and fuel injected gasoline or diesel engines only.
DO NOT install this Remote Car Starter in a standard stick
(manual transmission) or a vehicle that has a carburetor.
Serious personal injury or property damage could occur.
Never use the Remote Start on a vehicle that is in a garage
with the doors closed, an enclosed building, etc. Proper ven-
tilation is required to avoid serious personal injury.
Installation must be done by a qualified mechanic. We rec-
ommend that all connections be soldered.
PARTS LIST
•
Remote start module
•
Four button transmitter
•
Ten wire harness
•
Six wires for power and ignition hook up
•
Three wire harness for optional door lock/unlock
•
Three wire harness for optional power trunk release/
factory alarm disarm/vacuum switch
•
LED
•
Service/program switch
•
Pin switch
•
Bullet connector for pin switch
•
Antenna
•
Antenna double faced mounting tape
•
Antenna extension harness
•
Installation instructions
•
Operating instructions
Model RS125
1
®