Download Print this page

Connections - Gemini KIT ParkingSensor 814 Installation And Use Manual

Kit parking sensor

Advertisement

Clean thoroughly the plastic brackets (6 or 6a) and around the holes, apply
!
"PRIMER" (12), let dry for at least one minute and then proceed as follows.
+18°C
12
6 6a
7
Remove the protective film from the adhesive (7) and apply it to the bracket (6 or 6a) or snap the
bracket (8 or 9) in the hole from the outer part of the bumper.
I
n both cases position the plastic brackets so that the connector of the sensor comes out
8
9
6 6a
+18°C
1
BLACK
2
BLUE
Install the BLUE sensors on the outer edges of the rear bumper.
Install the BLACK sensors on the center of the rear bumper.
PAGE 06 - INSTALLER MANUAL
horizontally
.
NO
YES
Check the length of the cables before proceeding with the final positioning of the
!
!
Position the control unit (4) in the luggage compartment, in a dry place, away from eventual water
infiltrations and heat sources.
!
Run the cables along the rear bumper and route them inside the luggage compartment.
!
Fix the buzzer (3) inside the vehicle cabin where you can hear the warning signal. Make sure you
install it in a dry spot, away from eventual water infiltrations and heat sources.
!
Connect the BLACK-BLUE wire of the control unit wiring harness (5) to the positive of the reverse
light.
!
Connect the BROWN wire to the metal frame of the vehicle (ground).
!
Plug the buzzer (3) terminals with the YELLOW and BLUE wires to the main control unit connector
(5), respectively in positions 15 and 3.
!
(Optional) connect the GREY-RED wire for the "mute" feature to the corresponding wire of the car
radio preset for this feature.
!
Plug the 24-way connector of the rear sensors wiring into the corresponding connector of the
control unit (4).
To inhibit the system, ground pin 19 inside the wiring connector (5).
10
!
Automatic inhibition is also possible if the vehicle and the trailer are electrically
connected and an eventual free position is used to ground pin 19 of the connector (5).

6.0 - CONNECTIONS

MUTE
3
accessories.
This connection is usefull in case of towing.
INSTALLER MANUAL - PAGE 07
2
1
1
4
2
R

Advertisement

loading