Advertisement
Quick Links
INSTALLATION CERTIFICATE
The undersigned qualified installer attests to have personally fitted the here described system following the
manufacturer instructions.
By :
Sold on :
.................................................................
Car :
..........................................................................................................................
GEMINI Technologies S.p.A.
Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia
Tel. +39 0332 943211 - Fax +39 0332 948080
Web site: www.gemini-alarm.com
Type of product :
814
Reg. n.532-A
UNI EN ISO 9001:2008
KIT Parking
Sensor 814
INSTALLATION AND
USE MANUAL
UK
AC 2745/UK Rev. 02 - 10/11
Advertisement
Summary of Contents for Gemini KIT ParkingSensor 814
- Page 1 ..............INSTALLATION AND USE MANUAL Car : .......................... GEMINI Technologies S.p.A. Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia Tel. +39 0332 943211 - Fax +39 0332 948080 Web site: www.gemini-alarm.com Reg. n.532-A UNI EN ISO 9001:2008...
- Page 2 BLACK BLUE BROWN BLACK-BLUE MUTE GREY-RED MAIN UNIT BLACK BLUE Sensor 1: rear with shortest cable. Sensor 4: rear with longest cable. TECHNICAL SPECIFICATIONS 10 x Supply voltage From 9 to 30 Vdc Current consumption when system running 350mA max. Service temperature range From -30°C to +70°C Ultrasound frequency...
-
Page 3: Table Of Contents
The warranty will become void if labels are missing or torn, if the installation certificate is not fully compiled or if the enclosed sale document is missing. The warranty is valid exclusively at authorized Gemini Technologies centers. The manufacturer declines any responsability for eventual malfunctions of the parking sensors or any damage to the vehicle electrical system due to improper installation, use or tampering. -
Page 4: User Manual
INSTALLER MANUAL 3.2 - REAR SENSORS The rear sensors are activated when reverse gear is engaged; an audible signal will indicate the 5.0 - INSTALLATION OF SENSORS sensors are active. Detection of obstacles is signalled by the buzzer. The tone of the buzzer indicates in which detection zone the obstacle is located. To install the sensors on a metal bumper, you must use appropriate adapters (not The faster the beeping, the closer the obstacle.. -
Page 5: Connections
6.0 - CONNECTIONS Clean thoroughly the plastic brackets (6 or 6a) and around the holes, apply “PRIMER” (12), let dry for at least one minute and then proceed as follows. +18°C MUTE 6 6a Remove the protective film from the adhesive (7) and apply it to the bracket (6 or 6a) or snap the bracket (8 or 9) in the hole from the outer part of the bumper. -
Page 6: Programming
7.0 - PROGRAMMING 8.0 - SETTING OF PARAMETERS PARAMETERS RANGE SETTING Only expert users should modify these settings to avoid malfunctions of the parking system. Volume of buzzer 0, 1, 2 ( Ref.1 Detection range of rear central sensors From 120 to 180 cm ( Ref.2 The display will indicate: Detection range of rear corner sensors...