Projector SVGA User Manual page 30

USER GUIDE
The whole image appears to be unstable or misplaced
• Press reset.
• Adjust the frequency and tuning settings (instability), or the image
position settings (misalignment).
• Check that you are using a source with compatible resolution.
• The projector may be connected to a source with a non-standard
computer (or video card). Adjust the frequency and position of the
image.
Cooling fan is not working when lamp is lit
• If the fan does not work the projector must not be used and should
be returned to your dealer for repair.
The remote control is not working
• The red LED on the remote control should flash when transmitting. If
not, check the ON/OFF switch or the batteries.
• Make sure you point the remote control at the projection screen or
directly at the IR receivers. The front red LED indicator flashes when
receiving signals from the remote.
• The maximum range of the IR transmitters is 15m (50 feet) - Are you
standing close enough?
• If the effective range of the transmitters is significantly reduced, the
remote control needs new batteries.
The desktop mouse is not working
• Remember to follow this sequence when connecting the mouse:
- Connect the mouse cable.
- Connect the projector power cable
- Power on the computer
• You must boot the computer after the cable has been connected for
it to recognise the mouse. If you are unsure whether this was the
case, reboot your computer.
• Are the mouse cable (and mouse adapter) connections secure?
• Check the mouse driver settings on the computer
SVGA LCD PROJECTOR
29